Basic Weather Station BWS-200
8
4.2 Installing the Enclosure and Sensors
To install the enclosure and sensors you will need:
A spirit level
A tape measure
An adjustable spanner
A range of standard and Phillips screwdrivers
A compass (for wind direction orientation)
Cable ties
A set of Allen hex keys (at least a 3/16")
4.2.1 Mounting the Enclosure
Mount the enclosure onto the mast at a suitable height using the notched brackets
and ‘V’ bolts as shown in Figure 3, below. Adjust the position of the enclosure to
achieve the best exposure of the solar panel. When installing in latitudes greater
than 30 degrees from the equator, point the solar panel towards the equator, e.g.
facing due South in the Northern hemisphere. If the installation is within 30
degrees of the equator, the panel should be pointed towards the East to capture
energy from the sun during the morning (rather than mid-day when the sun is
overhead). It is important to ensure that no shadows fall on the panel from other
structures or vegetation.
Figure 3 Mounting the Enclosure
Nuts and Spring Washers
Enclosure
V-bolt and Notched Brackets
