Installation Manual
15
If you intend to use a different interface consult the instruction manuals for the
appropriate device.
2.
After powering up the datalogger as described in Section 7, above, use the
setup/connect tab in PC200W. Click on “Add” and follow the EZSetup
instructions.
PC200W EZSetup Settings for BWS200
Communication Setup
Choose the CR200X Series logger from the scrolling list.
Datalogger name: Enter a name up to 12 digits (CR200X Series is default)
CLICK NEXT >>
COM Port: COM1
COM Port Communication Delay: 00 Seconds
CLICK NEXT >>
DataloggerSettings
Baud Rate: 9600
Security Code:
Extra Response Time: 00 Seconds
CLICK NEXT >>
Setup Summary
CLICK NEXT >>
Communication Test
Check Yes
CLICK NEXT >>
If communication is unsuccessful then
a) ensure power is switched on (see section 7)
b) use standard RS232 lead provided and connect direct to station
c) contact Campbell Scientific
Datalogger Clock
Check the dataloggers clock and reset if required.
CLICK NEXT >>
Send Program
Do not send a program. Your BWS comes pre loaded with one.
CLICK NEXT >>
Wizard Complete
CLICK NEXT >>
If you have more than one Basic Weather Station, you will have to
set up a different datalogger (with a different, unique, name) for
each station to ensure that data from each station is collected
properly.
3.
The first thing to do when communications are established is to set the
datalogger clock using PC200W.
NOTE