CC5MPX & CC5MPX-Z Digital Network Camera
86
When using the optional Mounting Kit, align the outer holes of the CC5MPX
with the centre hole and the 180° slot of the mount. Loosely secure the two
together with the two ¼-20 x 0.5” Hex bolts included with the kit. It is now
possible to mount the CC5MPX to either a crossarm or other mounting surface
with the included u-bolt.
With the hardware loose, the camera and the L18549 can be pivoted to allow a
full range of motion when aiming the camera. The hardware should be secured
once the camera is properly aimed at the intended target.
The focus of the camera should be checked and adjusted as required. Refer to
Section 14.2 Focus and Zoom Adjustment for details. Be sure that the lens
tube is fully seated, the sun shroud is properly orientated after the camera is
aimed, and any protective caps are properly secured.
The sun shroud can be adjusted by loosening the Philips screws and turning the
shroud. When tightening the screws back up do not over tighten the screws as
the shroud may crack.
Figure 18-3 CC5MPX Mounted to Crossarm
19. Maintenance
The CC5MPX requires little maintenance and no calibrations. Keeping the
camera clean is important for the longevity of the camera and image and video
quality.
¼-20 x 0.5” Hex bolts
Sun Shroud
Lens Tube
U-bolt
Curved
Slots
Crossarm
