8.7.1 Sending an operating system to a local datalogger
Send an OS using Device Configuration Utility. This method requires a direct connection
between your datalogger and computer.
1.
Download
the
latest
Operating
System
at
2.
Locate
the
.exe
download
and
double-click
to
run
the
file.
This
will
extract
the
.obj
OS
file
to
the
C:\Campbellsci\Lib\OperatingSystems
folder.
3.
Supply
power
to
the
datalogger.
If
connecting
via
USB
for
the
first
time,
you
must
first
install
USB
drivers
by
using
Device
Configuration
Utility
(select
your
datalogger,
then
on
the
main
page,
click
Install
USB Driver).
Alternately,
you
can
install
the
USB drivers
using
EZ
Setup.
A
USB
connection
supplies
5
V
power
(as
well
as
a
communication
link),
which
is
adequate
for
setup,
but
a
12
V
battery
will
be
needed
for
field
deployment.
4.
Physically
connect
your
datalogger
to
your
computer
using
a
USB
cable,
then
open
Device
Configuration
Utility
and
select
your
datalogger.
5.
Select
the
communications
port
used
to
communicate
with
the
datalogger
from
the
COM
Port
list
(you
do
not
need
to
click
Connect).
6.
Click
the
Send
OS
tab.
At
the
bottom
of
the
window,
click
Start.
7.
On
the
Avoid
Conflicts
with
the
Local
Server
window,
click
OK.
8.
Navigate
to
the
C:\Campbellsci\Lib\OperatingSystems
folder.
9.
Ensure
Datalogger
Operating
System
Files
(*.obj)
is
selected
in
the
Files
of
type
list,
select
the
new
OS
.obj
file,
and
click
Open
to
update
the
OS
on
the
datalogger.
Sending an OS to a Local Datalogger
.
8.7.2 Sending an operating system to a remote
datalogger
If you have a datalogger that is already deployed, you can update the OS over a
telecommunications link by sending the OS to the datalogger as a program. In most instances,
sending an OS as a program preserves settings. This allows for sending supported operating
systems remotely (check the release notes). However, this should be done with great caution as
updating the OS may reset the datalogger settings, even settings critical to supporting the
telecommunication link.
1.
Download
the
latest
Operating
System
at
2.
Locate
the
.exe
download
and
double-click
to
run
the
file.
This
will
extract
the
.obj
OS
file
to
the
C:\Campbellsci\Lib\OperatingSystems
folder.
3.
Using
datalogger
support
software,
connect
to
your
datalogger.
l
LoggerNet
users,
select
Main
and
click
Connect
on
the
LoggerNet
toolbar,
select
the
datalogger
from
the
Stations
list,
then
click
Connect
.
8. Maintaining your datalogger
110
Summary of Contents for CR1000X
