CR200 Overview
FIGURE OV3-1. Power and Communication Connections
to the CR200
OV3.2 Using DevConfig to Set the PakBus Address
The CR200 default PakBus address is 1. Unless the CR200 is used in a
network, there may be no need to change the Pakbus address, or any other
default setting. To change settings, the Device Configuration Utility
(DevConfig) is used, as described below.
To set the PakBus address, the CR200 must be powered up and connected to
the computer as described in Section OV 3.1.
Run the DevConfig Utility. The DevConfig window is divided into two main
sections: the device selection panel on the left, and tabs on the right. Select the
CR2XX device, and the COM port on the computer that will be used for
communications.
OV-12
Summary of Contents for CR200
Page 2: ......
Page 31: ...This is a blank page...
