3. Click the Install USB Driver button. Carefully review the text on the right side of the screen.
Installing the driver only needs to be done the first time the computer is connected to an
RF451/RF452.
NOTE:
Install the device driver before plugging a radio into your computer for the first time.
You will need to have the device driver properly installed before you can connect to the
radio via USB.
4. With the USB device driver installation complete, connect a USB cable between the USB
port on your computer and the USB port on the radio.
5. Select the COM port. It should be listed in the dialog as RF451/RF452 (COM#) where # is
the COM port number.
NOTE:
It may take a few seconds for the Communication Port to become available for use after
physically connecting the RF451/RF452 to your computer.
6. Click Connect. The radio Status LED will turn yellow. After several seconds, a screen similar
to
(p. 29) will appear:
Figure 7-6. RF451/RF452 settings
CRVW3 3-Channel Vibrating-Wire Data Logger
29