Figure 8-9. CRVW3 latch closure and lock location
5. Install the Enclosure Lid Securing Screws into the four corners to ensure the maximum
protective seal between the lid and the main section of the enclosure.
TIP:
During future site maintenance, wipe off any water from the outside of the enclosure before
opening the enclosure lid.
9.
LoggerNet
configuration
Use
LoggerNet
for testing and validating deployed stations in your CRVW3 network. For
LoggerNet
to work properly, the computer running
LoggerNet
must first be physically connected
to the base radio station or configured with a telemetry link to the base station.
LoggerNet
is then
configured with details about the CRVW3 devices on your network, enabling connectivity. Once
you can connect to and collect data manually from each CRVW3 station on your network,
configure
LoggerNet
to collect data automatically, also known as scheduled data collection.
9.1 Physical connection to the base station
For wired connections between the
LoggerNet
computer and the base station, use a serial or USB
cable. For USB, a USB driver is active and will indicate the specific port number being used when
the device is plugged in. Otherwise, take note of which COM port is being used by your serial
cable.
CRVW3 3-Channel Vibrating-Wire Data Logger
53
