CS120A and CS125 Visibility and Present Weather Sensors
16
If applicable, use the following installation instructions.
Install the mount on a concrete foundation. If one does not already exist then a
concrete foundation should be constructed at least 600 mm square and 600 mm
deep. Ensure the ground consistency is not too loose and will be able to support
the mount and concrete foundation.
Drill four 12 mm diameter holes using the mount base as a template or
following Figure
Figure 7-7. Mounting footprint
Clean the holes of all debris.
Place washers and nuts on the ends of the wedge anchors supplied (to protect
the threads during installation).
Hammer the wedge anchors into the holes until the start of the threads are
below the surface.
Tighten the nuts until about 25 mm of thread protrudes above the surface.
Remove the washers and nuts from the protruding length screw. Then lower
the mount into place.
