CS225 Temperature String
18
FIGURE 7-1. Screen capture of SDI-12 Transparent Mode on CRBasic CR800
Datalogger using control port 1 and prompting for SD1-12 addresses
6.
To change the SDI-12 address, press the <enter> key. At the “CR800>”
”CR1000>” prompt enter the command SDI-12 and press the <enter> key.
Enter the appropriate control port, press the <enter> key, and enter aAb!;
where
a
is the current address from the above step and
b
is the new
address. The temperature sensor will change its address and the datalogger
will respond with the new address and then exit the SDI-12 Transparent
Mode.
Summary of Contents for CS225
Page 2: ......
