CS230/CS231 Temperature Profiler
2
The following procedure also shows using
Short Cut
to program the
CS230/CS231.
1. Open
Short Cut
and click
Create New Program
.
2. Double-click the data logger model.
3. In the
Available Sensors and Devices
box, type CS231 or locate the
sensor in the
Sensors | Temperature
folder. Double-click
CS230/CS231
SDI-12 Temperature Profiler
. Type the correct
Starting SDI-12
Address
for the first external probe or the top temperature point in the
rigid probe if no external probes are included (Section
(p. 9)
). Type the
Number of Result Sensors
.
4. Click the
Wiring
tab to see how the sensor is to be wired to the data
logger. Click
OK
after wiring the sensor.
5. Repeat steps 3 and 4 for other sensors.