A-1
Appendix A.
Importing Short Cut Code
Into CRBasic or Edlog Editor
This tutorial shows:
How to import a
Short Cut
program into a program editor for additional
refinement
How to import a wiring diagram from
Short Cut
into the comments of a
custom program
A.1 Importing
Short Cut
Code into a Program Editor
Short Cut
creates files that can be imported into either
CRBasic Editor
or
Edlog
program editor. These files normally reside in the C:\campbellsci\SCWin folder
and have the following extensions:
.DEF (wiring and memory usage information)
.CR6 (CR6 datalogger code)
.CR2 (CR200(X) datalogger code)
.CR300 (CR300-series datalogger code)
.CR1X (CR1000X datalogger code)
.CR1 (CR1000 datalogger code)
.CR8 (CR800 datalogger code)
.CR3 (CR3000 datalogger code)
.CR5 (CR5000 datalogger code)
.CR9 (CR9000(X) datalogger code)
.DLD (contain code for CR10(X), CR23X, CR500, CR510, 21X, or
CR7(X) dataloggers)
The following procedures show how to import these files for editing.
A.1.1
CRBasic Datalogger
Use the following procedure to import
Short Cut
code into
CRBasic Editor
(CR200(X), CR1000, CR1000X, CR800, CR3000, CR5000 dataloggers).
1. Create the
Short Cut
program following the procedure in Section 4,
Quickstart
. Finish the program and exit
Short Cut
. Make note of the file
name used when saving the
Short Cut
program.
2. Open
CRBasic Editor
.
3. Click
File
|
Open
. Assuming the default paths were used when
Short Cut
was
installed, navigate to C:\CampbellSci\SCWin folder. The file of interest has a
“.CR6”, “.CR2”, “CR300”, “.CR1”, “.CR8”, “.CR3”, “.CR5”, or “.CR9”
extension, for CR200(X), CR1000, CR1000X, CR800, CR3000, CR5000, or
CR9000(X) dataloggers, respectively. Select the file and click
Open
.
4. Immediately save the file in a folder different from \Campbellsci\SCWin, or
save the file with a different file name.
