A-1
Appendix A. EC150 Settings
Operation of the EC150 can be customized by changing the values of the
settings. Factory defaults will work well for most applications, but the user
may adjust the settings with a PC using either the
ECMon
software (see
) or the
Device Configuration Utility
(see
(p. A-9)
), or with a datalogger using
the
EC100Configure()
CR Basic instruction (see Appendix
EC100Configure() Instruction
(p. A-9)
).
When the EC150 is connected to a datalogger, the settings of the analyzer can
be configured automatically by the CR Basic program.
A.1 Factory Defaults
shows the default value for each of the settings.
TABLE A-1. Factory Default Settings
Setting
Default
SDM Address
1
Bandwidth
20 Hz
Unprompted Output
disabled
RS-485 Baud Rate
115200 bp
Unprompted Output Rate
10 Hz
Analog Output
disabled
ECMon Update Rate
10 Hz
Temperature Sensor
Auto-select (EC150 Temperature Probe)
Pressure Sensor
EC100 Basic or EC100 Enhanced (depends on
initial order configuration)
Pressure Differential
Enable
Auto-Select (Disabled for EC150)
Heater Control
Disabled
A.2 Details
This section gives an explanation for each setting. The value of each setting is
stored either in the non-volatile memory of the EC100 electronics or the EC150
gas head. The section also explains the details of where settings are stored. For
convenience all settings and calibration information associated with the
operation of the gas head are stored in non-volatile memory located in the
head.
Another group of settings pertinent to the operation of the EC100 electronics
are stored in non-volatile memory. These settings are the first seven in TABLE
. For more details refer to the following sections.
Summary of Contents for EC150
