6. Close the open end of the hinge plate and secure it with the thumb screw. Connect any
required wiring.
NOTE:
When wiring the component mounted on the hinge plate, always route the wires from
right to left, and then over the hinge. This allows the hinge to be opened without
putting stress on any wiring. Holes are provided in the leg to secure the wiring with zip
ties.
C.3 Enclosure leg stack mounting kit
overview
The Enclosure Leg Stack Mounting Kit is used to raise a component 2.76 cm (3 in) above the
surface of the backplate. This is beneficial when an enclosure nears its holding capacity of
components. Using the stack mounting kit allows one component to be stacked above another,
saving space in the enclosure. For example,
(p. 41) and
(p. 42) show a
CR1000X mounted above an AM16/32B. Any component mounted below a component being
stacked must be fully wired prior to installing the top component. Note that in this example, the
four grommets used to mount the CR1000X to the extension legs use the same hole pattern as
the CR1000X.
Enclosures
40