FIGURE C-8. CR1000X mounted to stack mounting kit legs
C.4 Enclosure leg stack mounting kit
installation
1. Determine the spacing needed between the two legs.
2. Secure the legs to the backplate using screws and grommets. If a component is to be
mounted under another and shares the same mounting holes as the leg, mount the pieces
in the following order: backplate, grommet, leg, component, screw.
3. Fully wire the bottom component before proceeding.
4. Insert grommets into the two legs where required for the component to be mounted on the
legs.
5. Place the top component in position and secure it with screws.
Enclosures
43