Campbell NL110, Instruction Manual

NL110 NTCIP Interface

9

TcpSer - This option configures the NL100 to act as a TCP/IP based serial
server when communicating with a datalogger over its RS-232 port.

RS-232 bps - This is the bits per second (bps) at which the NL110 will
communicate using the RS-232 port.  This is a fixed rate (i.e., it is not a
maximum baud rate or an autobaud rate).  Note that the CR10X-2M can
communicate at a maximum baud rate of 9600 bps, so to communicate
with one of those dataloggers, this setting must be 9600 bps or less.  The
default setting is 115K bps.

RS-232 serial server port number - Enter the port number, in the range of
1 to 65000, that will be used for communication.  The default port number
is 6784.

PakSer - The RS-232 port of the NL110 can be configured as a PakBus serial
server.  This sets up the device as a serial server.  In this mode, PakBus framing
is removed from the packet and routed via the RS-232 port.

RS-232 bps - This is the bits per second (bps) at which the NL110 will
communicate using the RS-232 port.  This is a fixed rate (i.e., it is not a
maximum baud rate or an autobaud rate).  Note that the CR10X-2M and
the CR510 can communicate at a maximum baud rate of 9600 bps, so to
communicate with one of those dataloggers, this setting must be 9600 bps
or less.  The default setting is 115K bps.

RS-232 Serial Server AppId number - Enter the application ID, in the
range of 1 to 65000, that will be used to identify the PakSer in the
network.  The default ID is 6784.

ConfMon - Configuring the RS-232 port as a ConfMon allows you to connect
directly to the NL110 via a computer and null modem.  There are no
parameters; the baud rate is automatically set to 115,200 bps.  Refer to Section
3.2.1 for additional information.

2.3.3.5  Ethernet 10 Base-T

EtherNet 10BASE-T (enabled, disabled) [enabled]:

10BASE-T port IP address [192.168.7.53]:

10BASE-T port network mask [255.255.255.0]:

Is there a default gatway (yes, no) [no]:

The 10 Base-T communications link is used to connect the NL110 to a TCP/IP
network using a Category 5 twisted pair cable.  The Ethernet 10 Base-T link
must be configured, or you will not be able to communicate with the NL110
over a TCP/IP connection.  The following options must be configured.  These
values should be provided by your network administrator.

10BASE-T Port IP Address - This number is the address of the NL110 on
a TCP/IP network.  It is written as 32-bit number written in four 8-bit
decimal-equivalent syllables separated by periods, in the format