Campbell NL110, Instruction Manual

NL110 NTCIP Interface

10

XXX.XXX.XXX.XXX.  The IP Address must be a static IP Address—the
NL110 does not support DHCP (dynamic host configuration protocol).

10BASE-T Port Network Mask - The network mask is used to help a
network router to more efficiently transfer information.  Typically, a class
C mask will be 255.255.255.0, a class B mask will be 255.255.0.0, and a
Class A mask will be 255.0.0.0.  The tighter the mask, the more the
NL110 will rely on the default gateway to route packets.

If you enter Yes for "Is there a default gateway", you will also need to
configure the following option:

IP Address of the Default Gateway - Enter the IP address of the device
that is responsible for forwarding information to destinations outside the
internal network, defined by the network mask.

2.3.3.6  PakBus Node ID

PakBus node Id (1..4094) [678]:

Clock neighbor node Id (0..4094) [1]:

If the NL110 is to be used in a PakBus network, a PakBus Node ID must be
assigned.  If the NL110 will not be used in a PakBus network, this setting can
be ignored.  All devices in the network must have a unique PakBus Node ID.
Valid IDs are 1 through 4094. The default ID is 678.

Clock Neighbor Node ID - In a PakBus network, a "neighbor" is another
PakBus device that the NL110 can communicate with directly (e.g., it does
not have to route data through another PakBus device to reach the
neighbor).  A neighbor can be designated for the NL110 as the device
from which the NL110 will accept a clock set command.  If this setting is
enabled, once the NL110 has received a clock set from its designated
neighbor, it will broadcast its clock information along with its beacon.
Thus, the NL110 can be used to set the clock of other PakBus devices in
the network.  Set this ID to 0 to disable the function.

2.3.3.7  PakTcp Server Config

PakTcp server config (enabled, disabled) [enabled]:

PakTcp server port number (3000..65000) [4001]:

Enabling this option will set up the NL110 to act as a server in a PakBus
network.  The NL110 can support up to three concurrent connections.  This
option must be enabled when the NL110 uses an Ethernet connection to
communicate with other PakBus devices in the network.  The NL110 will listen
for incoming TCP/IP packets on the socket designated by the PakTcp server
port number setting.  If the NL110 will not be used in a PakBus network, or if
the PakBus communication among PakBus devices in the network will take
place over a port other than the Ethernet connection, this setting can be
disabled.