Section 7. Short Cut Program Generator
that datalogger, unless it is changed via the Program menu. Note that
programs containing sensor files that are filtered from the list of Available
Sensors will still load and work correctly in Short Cut.
The AC Noise Rejection and the Sensor Support settings are
persistent settings for each datalogger model. The first time you
create a program for a particular datalogger model, you will be
presented with these two dialog boxes. The state of these
settings is saved between Short Cut sessions. Any subsequent
new or edited programs that are generated after a setting has
been changed will reflect the change as well.
NOTE
Each time you create the first program for a datalogger model
you will be presented with these dialog boxes (e.g., the first time
you create a CR10X program, you must initialize these settings;
the first time you create a CR1000 program, you must initialize
these settings).
The settings can be changed at any time and the datalogger
program will be regenerated to use the new setting when you
click the
Finish
button on the Home screen.
After making your selections, note that the title bar shows the datalogger type
and scan interval.
Once you have saved the file, the filename will replace “untitled.scw”.
7.2.2 Step 2 – Choose Sensors to Monitor
In step 2, you tell Short Cut which sensors you’ll be measuring. Short Cut
organizes sensors into application groups:
7-5
Summary of Contents for PC400
