PVS5120-Series Portable Samplers
29
8.2.1 Connecting to the VSC100/Sampler via
DevConfig
1.
Connect the
#
17648 USB cable to the front of the sampler controller
(VSC100) and the other end to the computer’s USB port (FIGURE
).
Wait for Windows® to install the driver before opening
DevConfig
.
User must have Admin rights on the computer to install the
drivers.
2. Open
DevConfig
. Select the
VSC100 Series
under the
Sampler
. Click
Communication Port
and select the correct
COM port
. Click
Connect
).
FIGURE 8-4. Device Configuration VSC100
3. Once connected to the VSC100, you are ready to configure your sampler.
4. Click the
Clock
tab at the top of the window (FIGURE
). Next click
Set Clock,
which syncs the sampler clock with the computer clock. The
sampler clock accuracy is 8.2 minutes/month over the temperature stated
temperature range or roughly 1 minute/month at 25 °C. Also the
VSC100’s internal battery maintains the clock settings (see Section
(p. 10)
, for more information).
If a new operating system is loaded to the VSC100, the clock
must be synced before deploying the sampler.
CAUTION
CAUTION
Summary of Contents for PVS5120 Series
