FIGURE 6-28. Loosely wire tie antenna cable
5. Drape the antenna cable between the pole and the enclosure (
FIGURE 6-29. Loosely drape antenna cable over back of enclosure
6. Use the 2.125 stainless steel U-bolt to attach the adjustable angle mounting bracket to the
pole. Depending on the size of the antenna, position the bracket directly below, or above,
the enclosure top mounting bracket. The top of an omnidirectional antenna should not be
higher than the top of the lightning rod.
a. Slide the U-bolt behind the pole and through the oval notches on the adjustable
angle mounting bracket (
(p. 46)).
Section 6. Installation
45