FIGURE C-3. Enclosure supply kit
C.2 PS24 installation
CAUTION:
The PS24 is purposely shipped without the battery mounted in its bracket. Do not install the
battery until instructed to do so.
1. Place the top enclosure bracket on the pole at approximately 10 m (3 ft) above the bottom
of the pole. The bracket should be installed with the hook side up, and facing north.
2. Slide the strut clamps into the bracket as shown in
(p. 86). Tighten the clamp
so that it doesn’t move.
CAUTION:
Do not over tighten the clamp!
Appendix C. PS24 24 Ah power supply with 10 x 12 inch enclosure
85