B.2.1 Changing an SDI-12 address
This example was done with a CR1000X, but the steps are only slightly different for Granite-series,
CR6, CR800-series, CR300-series data loggers.
1. Connect an SDI-12 sensor to the CR1000X.
2. Open
Device Configuration Utility
.
3. Under Device Type, type the data logger model and double-click on the model type. This
example uses a CR1000X directly connected to the computer USB port.
4. Select the correct Communication Port and click Connect.
5. Click the Terminal tab.
6. Select All Caps Mode.
7. Press Enter until the data logger responds with the data logger (CR1000X>) prompt.
TempVue 20 SDI-12 PT-100 Class A, Precision Air Temperature Sensor
27
