Wind Monitor Series
3
FIGURE 4-1. Wind monitor mounted to a CM200 Series Crossarm
with pn 17953 NU-RAIL®
4.2 Step 2 — Use SCWin Short Cut to Program Datalogger
and Generate Wiring Diagram
Short Cut
is an easy way to program your datalogger to measure this sensor
and assign datalogger wiring terminals. The following procedure shows using
Short Cut
to program the sensor.
1.
Install
Short Cut
by clicking on the install file icon. Get the install file
, the ResourceDVD, or find it in
installations of
LoggerNet
,
PC200W
,
PC400
, or
RTDAQ
software.
2.
The
Short Cut
installation should place a
Short Cut
icon on the desktop of
your computer. To open
Short Cut
, click on this icon.
Wind Monitor
pn 17953 NU-RAIL®
Mounting Pipe
(supplied with sensor)
CM200 Series Crossarm
Summary of Contents for Wind Monitor Series
