13
ENGLISH
5. Satellite search with the control unit
5.2 Satellite search
1.
Switch on the control unit at the standby button.
2.
The SEARCH LED flashes green during the search process.
3.
The SATELLITE LED of the last satellite used flashes green.
4.
To change the satellite, you must change the satellite with the arrow keys
within approx. 3-5 sec. while the LEDs are flashing. Later, a change is only
possible if the antenna has found a satellite beforehand.
5.
Confirm the satellite selection with the OK button or wait 3-5 seconds until
the satellite logs in automatically.
6.
After the selected satellite has been found, the SIGNAL LED lights up orange.
7.
If the selected satellite was not found, the ERROR LED lights up red.
8.
After a successful search, you can switch the control unit off again using
the standby button.
Note:
If you want to start the search at another location, simply press the standby button
to search for the last selected satellite.
Summary of Contents for Satmex Flat 2
Page 1: ...Satmex Flat 2 Bedienungsanleitung...
Page 21: ...21 DEUTSCH Notizen...
Page 23: ...Satmex Flat 2 user manual...
Page 43: ...21 ENGLISH Notes...
