-20-
Note:
Never position containers on the grill
hot plate.
Preheating
Let the grill hotplate preheat for about 3
minutes
(knobs
in
Grill
position
( )) to reach the ideal temperature
for cooking.
Cooking
-
The grill hotplates are coated with high
quality enamel, which allows healthy
cooking. Adding a slight film of oil is
recommended before any grilling.
They have two zones:
1.
Plain surface for contact cooking,
perfect for small slices of meat or fish,
small vegetables, toasts…
2.
Perforated surface, ideal for grills.
-
Because fats are collected in the water
tank, cooking is perfectly healthy (no
residual or burnt fats) and foods retain all
their taste and smoothness.
-
The grill hotplate reaches its maximum
temperature (ideal for sealing grills) after
about 3 minutes preheating.
-
Arrange the food on the grill hotplate.
-
It is also possible to modulate the
intensity of cooking depending on the
position of food on the grill hotplate:
maximum power in the centre of each
burner, more moderate towards the
outside.
-
When cooking is finished turn the knob
corresponding to the burner clockwise to
position (
).
Switching off
-
Close the regulator or gas cylinder valve.
-
After the flames have gone out, close
the stove valves by putting the knobs in
position (
).
G - REMOVING OR CHANGING
THE GAS CYLINDER
- Check that the gas cylinder valve or
regulator lever is in the closed position.
- Place the adjusting knobs in position
(
) by turning them clockwise.
- Disconnect the regulator from the gas
cylinder.
- Install the new gas cylinder.
- Connect the regulator to the new gas
cylinder (check the condition of the
regulator seal, before connecting it to the
gas cylinder).
H -
STORING THE APPLIANCE
FOR TRANSPORT
IMPORTANT: Start by removing the gas
cylinder, and check that all the valves are
in the (
) position and that the appliance
has completely cooled down.
400 SG and 600 SG models
•
If the appliance has been used as a Grill,
remove the grill hotplates and the water
compartments.
•
If the appliance has been used as a stove,
remove the pan supports from both burners.
-
Put the water compartments in place after
having emptied and cleaned them as
necessary.
-
Turn the pan supports over to be able to
insert the starred upper part into the
notches in the water compartment.
-
Fit the grill plates so that the pan support
wire attachment points pass through the
slots in the grill hotplates.
GB
Summary of Contents for 400 SG
