Campingaz CV Instructions For Use Manual Download

Page: 9 / 76

- Non-edged cooking plate (fig. 10): place the plate on

the water tray with the fat drainage hole at the rear.

- Check cooking plate stability.

Important: never stack cooking plates / pan

supports together when you are using your

grill (fig. 12).

2 - Lighting the burner with a push igniter (fig. 13)

a) Open the gas by turning the adjustment wheel (1) -

found on the regulator (2) - in a counterclockwise
direction (toward the " + " on the arrow) and push
once or twice on the ignition button (5) until the bur-
ner is lighted.

b) If the burner does not light, close the valve by tur-

ning the valve wheel (1) in a clockwise direction
(toward the "-" on the arrow) until it stops and check
to see that there is gas in the cylinder before re-
starting the operation.

3 - Manual burner lighting

a) Remove the cooking plate (8 or 9 - fig. 1) if neces-

sary.

b) Put a lighted match next to the burner.
c) Slowly open the gas by turning the wheel (1) - found

on the regulator (2) - in a counterclockwise direction
(toward the " + " on the arrow).

4 - Switching off

Close the tap by turning the control knob (1) - found on
the regulator (2) - clockwise as far as it will go (direc-
tion "-" of the arrow). Fully tighten the wheel to ensure
that the gas is completely turned off.

5 - Cooking

Pan support (7)

Put a pan on the pan support, center over the burner,
and adjust gas flow so that flames are not higher than
the pan.

Cooking plates

- The non-edged cooking plate (9) is perfect for

cooking eggs, thin slices of meat or fish, small
vegetables, toast, etc.

The edged cooking plate (8) is ideal for grilling.

Since fats from cooking fall into the water tray,
cooking is perfectly healthy (no residual or carboni-
zed fats) and food stays tasty and tender.

The plate attains a maximum temperature (ideal for
searing grilled foods) after 3 minutes of pre-heating
with the cover closed.

When the plate is hot, place the food on it and
adjust heat to the proper cooking level using the
adjustment wheel (1).

Cooking can be done with the cover closed.

E - REMOVING THE CARTRIDGE (fig. 6)

The cartridge may be removed even if it is not

empty. Replace the cartridge outside and away from

other people.

- Wait for the stove to cool down.
- Check that the gas supply is fully turned off by turning

the control wheel (1) clockwise to its full extent.

- Holding the regulator (2), unscrew the gas cartridge

by turning it as show in Figure 6 and remove it.

F - DISASSEMBLY, CLEANING AND STORAGE

If you take care of your device properly, you will be able
to enjoy using it for many years.
Do not clean your device when it is being used. Wait
until it has cooled to avoid burns caused by hot parts
(cooking plates, pan support, water tray, etc.)
a) After complete cooling, remove the cooking plate (8

or 9) or pan support (7) and the water tray (6).

b) Clean greasy parts with soap and water or a non-

abrasive detergent.

c) For easier cleaning, you can wash the cooking pla-

tes, pan support and water tray in a dishwasher.

- Cooking plates

The cooking plates are enameled. To clean them, we
recommend first removing all cooking residues with a
sponge or cleaning pad. Next, remove grease with a
dishwashing product. Be careful not to hit the
cooking grill against anything, since this could chip
the enamel.

d) After cleaning the water tray and the cooking plates,

place them in the device in the following order:

- water tray (6),
- pan support (7),
- edged cooking plate (8),
- non-edged cooking plate (9),

then pull both side locks toward the inside to lock the
cooking plates in place (fig. 11).
Close and lock the cover. The device can be carried
by its handle.

e) Store the equipment and the cylinder in a cool, dry

and well-ventilated area, out of reach of children.
Never store in a basement or cellar.

f) If the device will not be used for a long period of time,

disconnect the tank as indicated in paragraph E.

g) In the case of the injector becoming clogged (the

cylinder still contains gas but the equipment will not
light), do not try to unclog it yourself. Return the
equipment to your retailer.

h) If you use this equipment indoors, the area must obs-

erve elementary ventilation conditions enabling the
supply of air required for combustion and avoiding
any build-up of a dangerous mixture of non-burnt
gas (2 m

/h/kW minimum).

WARRANTY APPLICATION TERMS AND CONDITIONS

The product is covered by a total parts and labor war-
ranty for a period of 2 (two) years from its purchase
date. The warranty applies to products that do not
conform to the order or that are defective. Within the
guarantee period, the product shall be either repaired,
replaced or reimbursed - in full or in part. Liability to
Buyer under a claim shall in no event exceed the price
of the product.
The warranty is null and void and does not apply should
the damage arise from (i) abuse of the products (ii) fai-
lure to operate and maintain the products in accordance
with the instructions of use (iii) repair, service, alteration
or modification of the product by unauthorized third par-
ties (iv) original parts are not used.
The warranty is excluded in case of professional use.
Proof of the purchase date (ie. invoice, till receipt) and
claim report are required to obtain a free warranty service.
Do not return the appliance with the gas container (cylin-
der or cartridge) fitted; ensure it is dismantled before
sending back. Service under the guarantee does not
affect the expiry date of the warranty.
All other claims including for damages resulting from
this warranty are excluded unless ADG’s liability is
legally mandatory.
This guarantee in no way affects a Buyer’s statutory rights.
In the event of difficulty, please contact the Local
Customer Service in your country. List of contacts is
available in this leaflet.