11
6. Using the lantern (fig. 18) (models with lantern
only)
IMPORTANT:
Additional advice:
WARNING: After it has been burnt, the mantle becomes
very fragile - avoid touching it, as it will break easily.
- Do not use the lantern with a torn mantle as there is a risk
that the glass will break. Replace it only with the appro-
priate Campingaz® mantle.
- Remove the damaged mantle and brush away any debris,
then proceed as described under "Installing the mantle"
and "Burning the mantle".
6 -1. Lighting the lantern using the electronic ignition
- If the heater burner is not operating, open the gas supply
(cylinder valve or regulator lever).
- Switch the gas on by turning the control knob (20) anticlock-
wise, by about 1/4 turn. (towards "+")
- Press the ignition button (B) until the lantern lights, then
release the button.
- If several attempts are unsuccessful, check that the cylinder
contains some gas.
6-2. Lighting the lantern manually
- Apply a burning match or cigarette lighter (C) to the gap
between the glass and the cap, then gradually increase the
gas supply by turning the control knob (20) anticlockwise.
6-3. Adjusting of the brightness
- The brightness of the lantern can be adjusted by slowly turn-
ing the control knob (20) towards " + " or " - ".
6-4. Extinguishing the lantern
- Close the valve by turning the knob (20) fully clockwise (" - "
direction of the arrow).
7. Replacing the globe
ENSURE THAT THE PATIO HEATER IS COOL AND
SWITCHED OFF.
- Remove the cap (19) from the top of the globe (18).
- Remove the broken globe taking care not to injure yourself
with the sharp fragments
- Install the new globe and clip the cap on top (fig. 17).
8. Replacing the mantle
See the "Installing the mantle" paragraph.
9. Maintenance
9-1. Inspection of the flexible hose between the valves and
the heater burner
- Once per year, check the condition of the hose (which has no
date limit). To do this:
4
disconnect the regulator from the cylinder,
4
remove the control knobs (20) and (21),
4
position the reflector vertically,
4
unscrew the 5 screws (25) - fig. 22 - and remove the flange,
4
the flexible hose appears.
- Check that the flexible hose is free from any signs of perish-
ing, such as cracking, cuts or burns.
- If the hose has any defects, return the patio heater to your
supplier.
WARNING: DO NOT ATTEMPT TO REPLACE THIS HOSE
YOURSELF
- If there are no defects, reinstall the flange and secure it with
the 5 screws (25).
9-2. Flexible hose between the regulator and the head of
the patio heater
- Check the state of the flexible hose once a month and repla-
ce it if it shows signs of ageing or surface cracks.
- Replace the flexible hose with a new hose of the same length
and equivalent quality.
- The flexible hose (whether pre-fitted with endpieces or not)
should be replaced according to the timescale indicated
above depending on the country.
- Perform the leak tests in accordance with § 4.
10. Storage and operating anomalies
Only store the patio heater when it has completely cooled:
- Check that the gas supply is properly shut off at the gas cylin-
der (cylinder valve or regulator lever in the closed position).
I
MPORTANT:
Store the patio heater and its gas cylinder in a
cool, dry and well ventilated place. DANGER: always store
out of reach of children, never in a basement or a cellar.
Propane gas cylinders must be stored outside, in a well ven-
tilated area, away from inhabited buildings and their outbuild-
ings.
- For extended storage of the patio heater:
4
remove the cylinder from the patio heater,
4
place the reflector in the vertical position and protect it with
a cover, to prevent spiders from entering the venturis of the
burners (spider webs create long flames at the burner).
- In the event of jets becoming blocked (the cylinder still con-
tains gas but the patio heater will not light) do not attempt to
unblock them, return the patio heater to your supplier.
11. Guarantee conditions
The product is covered by a total parts and labour warranty for
2 years with effect from the purchase date, excluding return
transport charges that should be borne by the consumer. The
warranty applies when the delivered product does not conform
to the order or is defective, from the moment that the claim is
accompanied by proof of purchase date (e.g. invoice, till
receipt). The product should be returned carriage paid, com-
plete and assembled, to an authorised after-sales service cen-
tre, with the claim describing the nature of the problem. A pro-
duct for which a claim is being made may be repaired, replaced
or reimbursed, in full or partially. The warranty is null and void
and does not apply if the damage is caused by (i) incorrect pro-
duct use or storage, (ii) defective product maintenance or main-
tenance that fails to comply with the instructions for use, (iii)
repair, modification or servicing of the product by unauthorised
third parties, (iv) the use of non-original spare parts.
NOTE: the professional use of this product is not covered by
this warranty.
IInn ccaassee ooff ccoonnttiinnuueedd ddiiffffiiccuullttyy,, pplleeaassee ccoonnttaacctt yyoouurr llooccaall rreettaaiilleerr w
whhoo w
wiillll ggiivvee yyoouu ddeettaaiillss ooff tthhee nneeaarreesstt A
Afftteerr S
Saalleess
S
Seerrvviiccee ppooiinntt,, oorr ccaallll tthhee C
CA
AM
MP
PIIN
NG
GA
AZZ®
® CCuussttoom
meerr S
Seerrvviiccee aatt::
C
CO
OLLE
EM
MA
AN
N U
UK
K P
PLLC
C -- Gordano Gate Wyndham Way - Portishead
BRISTOL BS20 7GG ENGLAND
Tel: 01275 845 024 / Fax: 01275 849 255
W
WA
AR
RN
NIIN
NG
G:: Due to our policy of continual product development, the company reserves the right to alter or modify this
product without prior notice.
W
Weebb ssiittee:: w
ww
ww
w..ccaam
mppiinnggaazz..ccoom
m
GB
GB.qxp 08/12/2005 10:11 Page 3
