MANUAL USER WI-FI THERMOSTAT ATB100
Page 7
Inserting / replacing batteries
The replacement of the Campini Thermostat batteries must be performed when the icon
appears on the display and on the application. The user will also be notified with
push notifications and, if enabled, notifications via email.
The first icon (
)indicates that the batteries are low and must be replaced, the
second icon (
)indicates that the batteries are exhausted and the thermostat is no
longer in operation.
Attention: before separating the Campini Thermostat from the relative plate fixed to the
wall, remove the electric current from the system.
To separate the Campini Thermostat from the relative plate fixed to the wall, it is sufficient
to insert a suitable tool into the slot located on the right side of the Campini Thermostat
and exert a slight pressure until the front part of the device separates from the plate.
Warning
: if the metal contacts in the battery compartment are dirty, they must be
cleaned.At this point it is sufficient to replace the three AAA batteries respecting the
polarity, insert the Campini Thermostat in the plate fixed to the wall and restore the
electric current of the system.
