7
Sb500
CAUTION:
Make sure before you start that you will not damage any electrical wires hidden in the
walls!
Insert the motor housing (3) with the mixing rod (4) into the holding device.
Remove the mixing rod
• Remove the mixing rod from the motor housing by turning it briefly in an anticlockwise
direction.
Attaching Accessories
• If you would like to use the Multiknife or the whisking disc, first place the attachment on
the shaft of the mixing rod (see Illustration A) and then push it into the position shown in
Illustration B. If necessary, hold the shaft at the open end of the mixing rod tightly.
NOTE:
• Make sure that the pin located on the shaft fits into the slot of the attachment. Only in
this case can the attachment be inserted completely onto the shaft!
• Use the lifter (15) as a tool in order to release the components again (see Illustration C).
Attaching the Mixing Rod
• Lock the mixing rod into place by turning once. The marker dots (3a) are now positioned
one above the other.
Whisk
• If you would like to use the whisk (9), replace the mixing rod by the adapter (10). Lock the
whisk into place by applying moderate pressure to the driveshaft of the adapter.
Function and Accessories
Two-level control switches (2):
Level *: At this level it is possible to use the speed control to regulate the number of revolu
-
tions per minute.
Level **: This provides the maximum speed and cannot be regulated.
Table of Functions and Accessories (see below)
ENG
