13
SM2755
GB
WASHING INSTRUCTIONS
Detergent dispenser:
1 Prewash
2 Wash
Softener
Control panel:
A Table of programmes
B Extra functions
C On/off button
D Thermostat dial
E Programmer dial
F Machine “on” indicator light
Before using the washing machine, make sure that it has been installed correctly as reported
in the instruction book.
Daily use
1. Before placing the washing in the washing machine, make sure that there are no hard pointed
objects in the pockets (nails, screws, coins, pins, stones, etc.) as these can damage both the
clothing and the appliance.
2. To improve the performance of the wash, place the washing loosely in the drum without compressing
it. Do not overload the machine. A full load of particularly absorbent material such as bathrobes and
towelling can unbalance the washing machine during the spin phase. The automatic load-balancing
system distributes the washing as evenly as possible and automatically sets the best spin speed
to reduce vibrations to a minimum.
3. Close the door, making sure that no washing has become trapped between the door and the
gasket.
4. Place the correct amount of detergent in the appropriate dispenser 2. When using a liquid
detergent, insert the partition supplied. If the Prewash function is required, add detergent to
compartment 1. Add softener to the compartment marked with the symbol . After adding the
detergent, gently close the detergent drawer.
5. Choose and set the desired washing cycle program and temperature using the relative E and D
knobs.
WARNING!! Do not turn the programming knob to the left. If you pass the desired
program, continue to turn to the right until you reach the desired position again.
6.
Buttons B and C are used to select the extra functions.
7.
To start the wash, turn on the machine by pulling out the programming knob or (if present on the
washing machine) by pressing the On/Off pushbutton (the indicator light will turn on).
At the end of the washing cycle, the washing machine will stop at one of the STOP points on
the programming knob.
1. Turn off the washing machine by pushing the programming knob in or (if present on the washing
machine) by pressing the On/Off pushbutton.
2. Take out the laundry
3. With dry hands, unplug the machine
4. Close the water tap.
CORRECT WASHING PROCEDURE
22
