EU
EU
POLISH
MARK
POLISH
MARK
CDS-6IPECO User’s manual
11
Enter the new IP address for the device CDC-6IPeco (IP address must be on the same
subnet as the computer), subnet mask, the Default Gateway IP address (entering the
IP address of the gateway is only necessary if the device operates outside the local
network). Remember to set a unique IP address for the local network (each device
CDS-6IPeco must have a unique IP address). In contrast, subnet mask and gateway
must be identical throughout the network. Confirm changes with Save Changes button.
The device can automatically reset itself and then you will need to log in again.
!
Modules CDS-6IPeco allow you to scan the ether for use in the vicinity of the frequen-
cy. When setting the operating channel it is a very useful tool. It shows which chan-
nels to avoid, and which ones are free and can be used to transmit wireless signals
from IP cameras. The use of a channel that is already occupied by other transmission
lines may result in interference, or the total lack of transmission.
To scan channels, temporarily switch unit in slave mode (Cameras).
To do this, go to the menu
CAMERA CONNECTION SETTINGS → Wireless Settings
and
from the Mode menu, select the parameter
Slave (Cameras). Confirm with Save Changes.
6.3. Scanning the usage of operation channels.
Settings
recommended
