Settings required
WAN Connection Type in the WAN Settings tab should remain as VIDEO BRIDGE - this is
the default option recommended for use IP cameras.
To communicate devices with each other all wireless CDS-6IPeco units must use the
same SSID (set in the Wireless Settings tab, Link Name (SSID) parameter). When
setting SLAVE module (Cameras), you can search already working modules MASTER
(NVR / DVR) using the "Scan MASTERS" and select the module with which you want to
connect to from the list.
The changes must be confirmed by pressing Save Changes.
Then select the operating mode in the Wireless Settings Mode parameter:
MASTER (NVR / DVR) - for the collection point, connected to the DVR,
SLAVE (Cameras) - for broadcasting points, connected to the cameras.
The SSID must be unique for each receiving module running on a site.
!
6.5. SSID radio link name (only required for subsequent receivers).
a)
Another important setting is to declare the distance between transmitter and receiver.
In the menu CAMERA CONNECTION SETTINGS → Wireless in the Wireless Advanced
Settings, change the Distance parameter by entering the actual distance in kilometers
a)
The last step is to check the correctness of transmission between devices.
To check the information about connected CDS-6IPeco devices such as the MAC
address, signal strength, connection time, IP address, etc., go to the Link Status
menu.
The basic information about the wireless connection will appear in the Wireless Status
tab. In addition, the unit operating in MASTER mode (NVR / DVR) in the Wireless
Clients tab a list of wireless units CDS-6IPeco connected to the module will be visible.
Repeat steps 2 - 8 for each unit transmitting / receiving subsequently joining them
to your computer.
6.6. Transmission distance
6.7. Wireless transmission testing
b) When configuring the MASTER unit (NVR / DVR), you must select the frequency of the
radio link (Channel). As a standard the device is set to automatic channel selection
(DFS) but it is advisable to select a free, not used by other users operating channel.
The change is confirmed by clicking Save Changes. Before setting the operating chan
-
nel it is recommended to scan the radio frequency to check the busy channels. See
point 8.
13
EU
EU
POLISH
MARK
POLISH
MARK
CDS-6IPECO User’s manual
Settings required
