Receiver powered by PoE (NVR).
•
Set the dipswitch No. 1 to ON (receiver mode), set the operating channel by a table
identical to the transmitter, set DIP7 and DIP8 to ON (up)
•
Connect NVR with the network cable to the PORT 1 or LAN port in PoE power supply.
•
Connect included power supply 48VPoE to PORT 2
Note: Due to the existing PoE voltage of 48V in port 2 connection other than specified
in the instructions can cause damage to the recorder, switch or other IT equipment.
Receiver powered with PoE switch (NVR).
•
Set the dipswitch No. 1 to ON (receiver mode), set the operating channel by a table
identical to the transmitter, set DIP7 and DIP8 to ON (up)
•
Connect NVR equipped with PoE switch by the network cable to PORT 1. The receiver
will be powered directly from your PoE switch.
