TECHNICAL
SUPPORT
tel.+48 52 387 36 58
Mon–Fr 8.00 AM–4.00 PM
Full instructions available on www.camsat-cctv.com
Mobile monitoring system with LTE module
and bu
ff
er battery supply powered from 230V
compatible with any IP camera
QUICK START
ver. 1.1
Feature
Full instructions available on www.camsat-cctv.com
The mobile camera in transport should be turned o
ff
.
During start-up of iConstruction-CAM system, follow these steps:
EU
EU
POLAND
MADE IN
• iConstruction-CAM
• LTE Antenna x2pcs
• Gel battery
• Quick-connector mounting mounting accessories
• Steel safety cable
• Quick Start User Manual and CE Declaration
Producer:
CAMSAT Gralak Przemys
ł
aw
Ogrodowa 2a
86-050 Solec Kujawski
Poland
camsat@camsat.com
+48 52 387 10 97
+48 52 387 36 58
+48 52 387 54 66
Sales:
camsat@camsat.com
+48 52 387 10 97
(ext. 21 and 22)
Mon.-Fri. from 8.00 to 16.00
European websites:
www.camsat.com
www.camsat-cctv.com
Technical support / Service:
serwis@camsat.com
+48 52 387 36 58
(ext. 25 and 26)
Basic information
The iConstruction-CAM device is a mobile observation system designed for monitoring of construction
sites, in places that are particularly di
ffi
cult to secure due to unfavorable conditions.
It enables very fast installation of the device on the site without complicated installations and projects.
In case of a power failure, the power supply is ensured by a gel battery that allows the device to
operate for a minimum of one hour with a rotating camera(up to 30W) or two hours with an tubular
or dome camera (up to 12W). The integrated LTE wireless module with two SIM card sockets allows
you to view the image from the camera from any place in the world and provides connection with the
recorder in your o
ffi
ce or server room.
Starting at the destination point
The iConstruction-CAM system with the IP camera should be mounted only for permanent, stable
construction of walls and masts. The holder should be mounted vertically, the handle/padlock must be
at the bottom. Additionally, you should install steel safety cable to a separate anchors or any other part
of the pole. Safety cable must be mounted to a solid, robust construction, which will guarantee the device
with the camera will be held in case of an emergency. The power plug should be plugged into a socket
adapted to the conditions of use, such as an external hermetic socket or a socket with a plug closed in
another hermetic housing or box. The installer is responsible for correct camera installation in accordance
with these instructions and safety standards!
Slide the camera (antenna up) into the holder, and then attach the safety cable and padlock to secure the
camera or twist two caps on the bolts to prevent unauthorized assembly.
After turning the ignition to the "I" it should light up green LED on the internal panel for a while.
iConstruction-CAM starts to record the image, and full remote access to the device will be possible.
WARNING
After mounting iConstruction-CAM, push ON switch inside, leaving it in position "1"
and close the case to prevent the shutdown of the system by third parties.
Actions taken during each system start-up
Package content
TECHNICAL
SUPPORT
tel.+48 52 387 36 58
Mon–Fr 8.00 AM–4.00 PM
www.camsat-cctv.com
The camera will be started after pushing ON/OFF switch inside case.
Push switch into "I" state to turn on device. Push "O" to switch off.
Battery charging should take at least 12h for 0-100% charging.
