10
RJ-45 Cable
Follow the instruction below to waterproof the connector of the RJ-45 cable.
Plug the Ethernet cable to the connector of
the RJ-45 cable and coat the joint with
silicone gel. Make sure there is no gap
between the Ethernet cable and the
connector; otherwise, waterproof function
cannot be guaranteed.
IP66 RJ-45 Cable
For IP66 RJ-45 cable, please use an RJ-45 IP66 plug for connection to prevent
water damage. Follow the steps below for cable connection.
Step 1:
Loosen the thread-lock sealing nut on the
RJ-45 IP66 plug, and take out the supplied
connector from the plug. Thread the Ethernet
cable through the thread-lock sealing nut and
the RJ-45 IP66 plug. If the Ethernet cable is
already attached to a connector, please
remove it first.
Step 2:
Carefully remove a section of rubber coating
from the end of the Ethernet cable to reveal
the wires. Inset the wires to the correct pins
of the connector. Plug the Ethernet cable to
the connector of IP66 RJ-45 cable.
Step 3:
Fasten the RJ-45 IP66 plug to the connector
of the IP66 RJ-45 cable. Lastly, tighten the
thread-lock sealing nut to the plug.