DOME COVER
LED COVER
SCREW
CAMERA MODULE
SCREW
CABLE
DISK
BASE
CONTROL PCB
PUSH BUTTON
HARNESS
SCREW
DUAL POWER PCB
Ø100
Ø130.8
Ø109
48.1
101
SUPER SUPREME RESOLUTION
3-AXIS D&N IR DOME CAMERA
CS-PD6600
MANUAL
1. Opening the dome :
Pushing the latch button.(Remove the
protectionsheet after installing.)
◐ HOW TO INSTALL
2. Removing the dome :
Lift the dome. When you push the latch button,
it is unlocked and you can lift the dome.
PROTECTION SHEET
LATCH BUTTON
SCREW TP1
3.5x20 2EA
SCREW TP1
3.5x20 2EA
R
L
U
D
ROTATION
LENS COVER
DISK
CAMERA
HOLDER
1. SONY Effio-E2 DSP adopted
2. 25M range visible in total darkness with 24pcs of IR LEDs.
3. Adopted 2-DNR technology, It reduces noise efficiently in low light
condition.
4. ATR(Adaptive Tone Reproduction)
5. Day & Night function
6. Super Supreme Resolution(700 TVL - Color)
7. Multi function : High Light Mask, Motion Detection, Privacy Mask,
efect Pixel Correction, Mirror
8. Multi-language full OSD support
◐ FEATURES
◐ DIMENSION
◐ ASSEMBLY
1. Do not install the camera outdoors.
2. Choose an ideal location for the camera, since a camera unit must
be protected against vibration.
3. Be careful not to scratch the camera unit, especially lens or dome
cover.
4. Use the camera within the temperature.(-45℃~50℃)
5. Avoid any direct sun light toward the lens.
6. Use the AC adaptor 12V DC, 1A regulated. Dual voltage product
can use 24V AC, 1A adaptor.(option)
◐ PRECAUTION
If the product is to be put out of operation definitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
3. Camera installation :
(1) Fix the camera set with the supplied screws on ceiling or wall
mount. If you don't use supplied screws, the camera may fall off.
(2) Please refer to '4. Camera angle
adjustment' regarding adjust camera
angle.
(3) Lens adjustment(Vari-focal Lens only)
After opening the LED cover,
① By turning the "Tele-Wide" knob, you
can access a range of focal lengths
within specified limits.
② Since then, by turning the "Near-Far"
knob, you can set the focus toward the wanted object.
(4) Re-assemble the camera.
<Ceiling mount>
<Wall mount>
4. Camera angle adjustment :
(1) Pan adjustment :
Grasp the disk of camera and then adjustdirection
to the right or left(-180
˚
~180
˚
)
(2) Tilt adjustment :
Grasp the LED cover of camera and then adjust
direction to the up or down(6
˚
~ 90
˚
)
(3) Roll adjustment :
Grasp the camera holder and then rotate
(-178
˚
~178
˚
)
<Caution> If you try to adjust the camera out of limited angle, it might
cause troubles and damage to camera.
1
2
w
N
F
T
