3
INSTALLATION GUIDELINES
CAUTION: Be careful to not inverse the Braking
system’s master cylinder when unpacking and
handling the rear of the DTS System. There is a
risk of air forming in the hydraulic component of
the Braking system.
PREPARATION OF COMPONENTS
FRONT SKI
To assemble the parts designed to adapt the
Front Ski Upright to your motorcycle, proceed as
follows:
• Install one of the Side Plates (
A-7
) on the right
side of the Ski Upright (
1
). See Figure 1.
Figure 1
• Insert the two upper rods (
A-6
) in the openings
of the Ski Upright. The flats machined on the
ends of the shafts must be positioned in the
openings of the Side Plate installed in the
preceding step. See Figure 2.
Figure 2
• Install the second Side Plate (
A-7
) on the left
side of the Ski Upright. Align the upper shafts
with the openings in the Plate. Press the parts
together to complete the assembly of the Side
Plates to the Ski Upright. See Figure 3.
Figure 3
• Insert T-Bushing (
A-2
) in the Ski Upright’s lower
left hole. See Figure 4.
NOTE: The hole on the left side is smaller than the
one on the right. Make sure to insert the
correct T-Bushing on the Ski Upright’s left side.
Figure 4
• Insert T-Bushing
(A-3)
in the Ski Upright’s lower
right hole. See Figure 5.
NOTE: The hole on the right side is larger than the one
on the left. Make sure to insert the correct T-
Bushing on the Ski Upright’s right side.
Figure 5
