Camtec Power Supplies GmbH - Gewerbestrasse 30 - 76327 Pfinztal - Germany
p. 5/5 (07.2014-04-1)
Phone +49(721)46596-0 - Fax +49(721)46596-77 -
www.camtec-gmbh.com
-
info@camtec-gmbh.com
(Subject to alterations. This product is not designed to be used in applications such as life support systems wherein a failure or malfunction could result in injury or death
Ordering Codes
Model (DIN-Rail standard) Information
Camtec Article Number
HSE03201.05T
5V
3041056099CA
HSE03201.12T
12V
3041056014CA
HSE03201.15T
15V
3041056015CA
HSE03201.24T
24V
3041056017CA
HSE03201.36T
36V
3041056020CA
HSE03201.48T
48V
3041056018CA
HSE03201.60T
60V
3041056019CA
Connector Power Good ** 2pole, 10 pcs per pack, lead space 5,08mm
3520037
** Note that the power good contact connectors are not a part of the power supply and require separate order
Safety regulations: Please read these instructions completely before using the equipment. Keep these
instructions on to hand. The device may only be operated by trained specialist staff.
Installation:
1) The device is designed for devices and systems
that meet the standard requirements for hazardous
voltages, power and fire prevention.
2.) Installation and service only by trained persons.
The AC power must be switched off. The work is to be
labeled; accidental reconnection of the system must
be prevented.
3.) Opening the device, its modification, loosening
bolts or operation outside the specified herein
specification or in an unsuitable environment, has the
immediate loss of warranty to follow. We disclaim any
responsibility for any resulting damage to persons or
things.
4.) Note: The device must not be operated without an
upstream circuit breaker (CB). We recommend the use
of a 4A type-B for 230Vac and 6A type-B for 115Vac. It
is prohibited to use the unit without PE. It may be
necessary upstream device has a power switch.
Warning:
Non-compliance can result in fire and serious injury or
death.
1. Operate the appliance without PE connection.
2. Before connecting the device to the AC
network, make wires free of voltage and assure
accidently switch on.
3. Allow neat and professional cabling.
4. Never open nor try to repair the unit. Inside
are dangerous voltages that can cause electrical
shock hazard.
5. Avoid metal pieces or other conductive
material to fall into the item
6. Do not operate the device in damp or wet
conditions
7. Do not operate the unit under EX-conditions
All parameters base on 15 minutes run-in @ full load / 25°C / 230Vac 50/60Hz, as otherwise stated.
