1
INTRODUCTION
Camus Hydronics proudly introduces its Blue-Flame Series of Water Heaters / Hydronic Boilers.
These machines are thoughtfully designed for easy operation and maintenance. We are confident
that you will come to appreciate the benefits of our product.
1. GENERAL INSTRUCTIONS
The installation of this heater must conform to the requirements of the authority having
jurisdiction or, in the absence of such requirements, to the National Fuel Gas Code, ANSI
Z223.1 or CAN/CGA B149 Installation Codes. All electrical wiring must be done in accordance
with the requirements of the authority having jurisdiction or, in the absence of such
requirements, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code
Part I, CSA C22.1 Electrical Code.
Vent installations must be in accordance with Part 7, Venting of Equipment, of the National Fuel
Gas Code, ANSI Z223.1, or Section 7, Venting Systems and Air Supply for Appliances, of the
CAN/CGA B149.1, Installation Codes and applicable provisions of the local building codes.
When required by the authority having jurisdiction, the installation must conform to the Standard
for Controls and Safety Devices for Automatically Fired Boilers, ANSI/ASME CSD-1.
The qualified installer shall instruct the end user in the safe and correct operation of this
appliance and shall ensure that the heater is in safe working order prior to leaving the job site.
WARRANTY:
Factory warranty shall apply only when the boiler is installed in accordance with:
•
Local codes, standards, ordinances and regulations,
•
The printed instructions provided with the boiler and;
•
Good industry practices.
Excessive water hardness causing a lime build-up in the copper coils or tubes is not a
fault of the boiler and is not covered by warranty. Consult the factory for
recommendations for use in hard water areas.
Using or storing corrosive chemicals in the vicinity of this boiler can rapidly attack the
copper tubes and coils and voids warranty.
This boiler is intended to operate under non-condensing conditions. Inlet temperatures
must be maintained at 110
°
F or higher. Warranty is void if heater is allowed to operate in
condensing mode.
Damage caused by freezing or dry firing voids warranty.
This boiler is not to be used for temporary heating of buildings under construction.
Summary of Contents for BLUE-FLAME Series
Page 21: ...19...
Page 22: ...20...
Page 23: ...21 21 EXPLODED VIEW...
