MAINTENANCE PROCEDURES
To confirm proper adjustment, gently
push on adjustment screw using a fin-
ger or a screwdriver. A small axial play
(0.5 mm) should be felt, if not, perform
adjustment again.
NOTICE
A premature clutch disk
wear may occur if adjustment is too
tight.
vmo2008-011-071_b
1. Adjustment screw
vmo2009-010-105_a
1. Adjustment screw
A. Axial play (0.5 mm)
8. Reinstall access plugs.
NOTICE
Do not overtighten.
vmo2008-011-042_c
1. Access plug
9. Properly adjust clutch lever. Re-
fer to
ADJUSTMENT AT CLUTCH
LEVER
above.
Throttle Cable
Throttle Cable Lubrication
The throttle cable must be lubricated
with cable lubricant (P/N 293 600 041)
or an equivalent.
WARNING
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable to
become sticky or stiff.
1. Remove the throttle lever housing
cover.
104
______________
Summary of Contents for DS 450 EFI X mx
