ENGINE/TRANSMISSION
Among other things, this section gives
the procedures to replace the liquids.
Refer to
LIQUIDS
for procedures to
check levels and refill.
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.
WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Remove drain plug and drain all oil
from oil tank. Wipe out any oil spillage
on frame.
V02C4XY
1
UNDER VEHICLE
1. Oil drain plug
Allow enough time for oil to flow out
of oil filter.
Unscrew oil filter cover.
Remove the oil filter and replace by a
new filter.
NOTE:
Check and change the O-ring,
if necessary.
V02C04Y
2
1
3
RH SIDE OF ENGINE
1. Oil filter cover
2. Oil filter
3. O-ring
Wipe out any oil spillage on engine.
Change gasket on drain plugs. Clean
gasket area on engine, oil tank and
drain plugs then reinstall plugs.
Refill oil tank at the proper level with
the recommended oil. Refer to
SPEC-
IFICATIONS
for capacity.
Start engine and let idle for a few min-
utes.
Check if the RED indicator lamp stay
ON, if so, stop engine and bleed sys-
tem by removing oil filter and bleeding
screw.
_____________________
97
Summary of Contents for DS 650 X
