Can-Am OUTLANDER 6x6 T 2021 Series Operator'S Manual Download

Page: 16 / 212

II SPECIAL SAFETY MESSAGES

– Always check for obstacles before operating in a new area. Never attempt to

operate over large obstacles, such as large rocks or fallen trees. Always follow
proper procedures when operating over obstacles as described in

RIDING

TECHNIQUES

in this Operator's Guide.

– Always be careful when skidding or sliding. Learn to safely control skidding or

sliding by practicing at low speeds and on level smooth terrain. On extremely
slippery surfaces, such as ice, go slowly and be very cautious in order to reduce
the chance of skidding out of control. If you are operating a 2-UP model and
have a passenger on-board, never attempt skidding or sliding; overturn or
passenger ejection may occur.

– Never operate this vehicle through deep or fast flowing water. Water should

never exceed footrests. Remember that wet brakes may have reduced stop-
ping ability. Test your brakes after leaving water, mud or snow. If necessary,
apply them several times to let friction dry out the pads.

– Always keep in mind that braking distance is readily affected by but not limited

to; weather and terrain conditions, braking system and tire conditions, vehicle
speed and attitude, and vehicle load including towing. Remember to adjust
your driving accordingly.

– Always be sure there are no obstacles or people behind the vehicle when you

operate in reverse. When it is safe to proceed in reverse, go slowly. Take into
account that on a 2-UP model the passenger can obstruct your view.

– BRP recommends sitting on your ATV when operating in reverse. Avoid stand-

ing up. Your weight could shift forward against throttle lever, causing an unex-
pected acceleration and may lead to a loss of control.

– Never exceed the stated load limits for this vehicle including operator, passen-

ger (2-UP models) and all other loads and added accessories. Cargo should be
properly distributed and securely attached. Reduce speed and follow instruc-
tions in this guide for carrying cargo or pulling a trailer. Allow greater distance
for braking.

– Always inspect and confirm the safe operating condition of your vehicle prior to

ride. Refer to

PRE-RIDE INSPECTION

subsection in this Operator's Guide. Al-

ways follow the maintenance schedules as described in this Operator's Guide.
Refer to

MAINTENANCE

section.

– Never operate the vehicle if the controls do not function normally.
– Always maintain proper tire pressure. When replacing tires, use only the rec-

ommended tire size and type. For tire information, refer to

SPECIFICATIONS

in this guide.

– Riding your vehicle too fast for the conditions may result in injury. Apply only

enough throttle to proceed safely. Statistics show that high speed turns usually
result in mishaps and injury. Always remember that this vehicle is heavy! Its
pure weight alone may entrap you should it fall resulting in injury.

– This vehicle is not designed for jumping, nor can it fully absorb the high impact

energy generated during manoeuvres such as jumping which, can be passed on
to you, the operator. Performing wheelies can cause the vehicle to flip over onto
you. Both practices have a high risk for you and your passenger (2-UP models)
and should be avoided at all times.

2-UP Models

Driver must:

– Not forget is responsible for the safety of the passenger.

_______

A) SAFETY INFORMATION

_______