7
This colouring can be removed using a finely abrasive pad.
The shine of stainless steel parts can be maintained by washing them with warm soapy water. Periodical cleaning with a special
product for cleaning steel is recommended.
The burner caps and flame dividers must be periodically removed and washed to eliminate encrusted food. Caps and flame
dividers must be washed with warm soapy water, rinsed thoroughly and dried. They can also be washed in a dishwasher.
Do not use jets of steam to clean the appliance.
Before reassembling the parts, check that the holes in the flame divider are not blocked by foreign bodies.
For the correct assembly and reassembly of the burner parts, see figure 2.
Figure 2 a)
To fit/release the burner cap, turn it slightly so that the pins slot into position.
Figure 2 b): flame divider
Figure 2 c): cap (underside)
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the
parts. The removal of other burner parts is forbidden.
When cleaning the cut-off device, operate gently using a wet sponge.
The removal of parts of the appliance other than the burners (within the limits indicated above) or the pan restraint accessories is
forbidden.
perni di fissaggio dello
spartifiamma e del cappellotto
holes for passage of the fastening pins
termocoppia
hole for passage of the cut-off device
recesses for coupling with fastening
pins
Summary of Contents for PC Series
Page 1: ...MANUAL INSTRUCCTION PC series FC series FN series PVseries...
Page 45: ...45...
Page 46: ...46...
Page 47: ...47...
