Controllers Area Networks Inc.
Smart Tweezers User Manual Version 1.0
Page 6 of 16
The Jog Dial Button
The Jog Dial
button (Figure. 3) is used to choose the selected function or to change a
setting.
To change the menu displayed press and move the button left or right.
To select or execute a function press the button down (Figure 3).
10 kHz
Figure 3.
Reset Button
The reset button resets the unit. This may need to be pressed after changing the
batteries.
Virtual Ground
Use the Virtual Ground connector when performing in-circuit measurements to
eliminate the influence of grounded components. Connect this point to the circuit
Ground.
Important: Do NOT
use the virtual ground when the tested circuit is under the
power.
Slide Switch
The slide switch can optionally be used to measure DC voltage up to 8V by
enabling a 1/10 voltage divider.
Important:
The slide switch should be turned off once the voltage measurement is
completed. If it is not turned off incorrect results in automatic mode may occur. The
slide switch is not an automatic control option.
