SWIFT CURRENT SPA
NOTE:
• The massage system will stop automatically after 30 minutes of operation. You can re-activate the jet
function by pressing the ‘JETS’ button. NOTE: Heater will automatically turn on when jets turn off.
• Heating and jet function cannot be activated at same time. When heating system is working, pressing the
‘JETS’ button will change heating mode into jet mode: heating and filtering are shut down, jet system is
activated. When jets are turned off, heating and filtering automatically resumes.
NOTE: Keeping jets on for a long period of time may cause spa water to lose heat.
• Pressing ‘HEAT’ activates the heating and filtering system at the same time. The ‘HEAT’ button will display
a solid red light as spa water heats up. Once desired temperature is reached, the heater will go into standby
mode, which will be indicated with a flashing red light.
NOTE: Heater will not resume until spa water drops 2 degrees below set temperature for maximum
efficiency. You can also manually restart the heater by pressing ‘HEAT’ when heater is turned off.
Jets Massage System
‘JETS’ Button:
Press the ‘JETS’ button to activate the Jet Massage System on the spa. Pressing once will start
the lowest speed of the jets (L-1 will display on the screen). Press again to increase the speed of the jets to L-2, and
press again to reach the highest jet speed, L-3. Hold down the ‘JETS’ button for 5 seconds to turn jets off. When jets
turn off, ‘FIL’ will display on the screen to indicate the filtration and heat is back on. When jets mode is on it will flick
between the speeds (l-1, 2 & 3 & BUB).
NORMAL
41ºC
42ºC
L - 1
L - 2
L - 3
F I L
Temp and Over-heat
cycle 41
º
C and 42
º
C
‘Temp up’ Button:
Press the ‘Temp’
up button for 5 seconds and hold and
temp will raise to 41ºC or 42ºC the
next cycle it will go back to the max
temp of 40ºC on the following cycle.
(10)
