EL/GL Series - Mach 3
13
THE CANADIAN SPA COMPANY OWNERS MANUAL
Initial Start-up
When your spa is first actuated, it will go into Priming mode
(after displaying some configuration information). Please
see the M-7 Installation Instruction Manual for complete
instructions on Power-up and Pump Priming.
The Priming mode will last for up to 4 minutes and then the
spa will begin to heat and maintain the water temperature
in the Standard mode. You can exit Priming mode early by
pressing “Warm” or “Cool.”
Setting the Time
Once the spa has been properly connected the first time (every power up on the EL1000 and some
EL2000 systems), notice the TIME icon appearing on the screen.
Press then
Select the hour by pressing
Or
Each press changes
the time by 1 hour
Press to
enter.
Select minutes by pressing
Or
Each press changes
the time by 1 minute
Press
to exit the time setting procedure and enter the
optional filter cycle programming. (Exits programming
on some EL1000 and some EL2000 systems.)
Press
exit programming.
ML700 Quick Reference Guide
Time
When time hasn’t been programmed, the “TIME ” icon
flashes. (Time settings on EL1000 and some EL2000
systems are not preserved in the event of power loss; time
will have to be reprogrammed upon each power up.
owners stitched 21/1/10 3:40 pm Page 15
