Diagnostic Messages
18
THE CANADIAN SPA COMPANY OWNERS MANUAL
Inadequate water detected in heater.
Check water level in spa. Refill if necessary.
If the water level is okay, make sure the
pumps have been primed. Press any
button to reset.
Inadequate water detected in heater.
(Displays on third occurrence of the above
message.)
Spa is shut down.
Follow action required for the above
message. Spa will not automatically reset;
you may press any button to reset.
When your spa is first actuated, it will go
into Priming mode.
See the M-7 Installation Instruction Manual
for complete instructions on Power-up and
Pump Priming. The Priming mode will last
for up to 4 minutes and then the spa will
begin to heat and maintain the water
temperature in the Standard mode.
Temperature unknown.
After the pump has been running for 1
minute, the temperature will be displayed.
Temperature not current in Economy or
Sleep mode.
In Economy or Sleep mode, the pump may
be off for hours outside a filter. If you wish
to see the current spa temperature, either
switch to Standard mode or turn
Jets 1 on for at least 1 minute.
Standby Mode has been activated by
pressing a button combination on the user
panel.
Press any button to leave Standby Mode
and return to normal operation.
Message
Meaning
Action required
owners stitched 21/1/10 3:40 pm Page 20
