3
w w w w . c a n a d i a n s p a c o m p a n y . c o m
Assembly:
Inflate the spa lid using the same inflation
procedure as the spa body.
Attaching the Control Unit:
Ensure that the Blower Check valve, located
under the Control Unit (see photo right), is tightly
securely. These can sometimes become dislodged
during shipping, and cause malfunctions.
7
Rio Grande portable spa - Assembly Guide
Next align/screw the
Connectors to the
Control Unit with the
appropriate input port(s)
on the spa as highlighted
(see symbols for correct
alignment).
88
On the inside of the spa there is an internal drain
plug. On the outside of the spa there is a drain
cap - ensure both are securely tightened before
filling the spa with water.
9
Next place a garden hose in the spa and fill with
cold water until reaching the water level
indicator printed on the spa inner wall. Note: Do
not fill with hot water as this will effect the preset
thermostat settings.
10
Now add the Thermal
cover and the spa lid to
retain heat - then secure
the locking straps prior to
heating.
11
