11
+
+
6) Attach Connectors to Top Liner and feed
through corresponding holes in Foam
Panel 1.
NOTE:
Attach T-Connector after
completing Step 8.
8) Feed Secondary Intake Hose through
channel on Foam Panel 2 and
attach to T-Connector on Foam
Panel 1. Feed T-Connector through
corresponding hole in Foam Panel 1 and
attach to Top Liner.
9) Zip up Bottom Liner. Pull Top Liner Down,
smoothing out wrinkles as you go. Make
sure zipper is aligned with Bottom Liner.
Zip up both liners.
7) Attach L-Connector to Secondary Intake
Hose. Attach L-Connector to Top Liner
by feeding through hole in Foam Panel 3
and securing to corresponding
Connection Port on Top Liner.
5) Insert the Top Liner into the center of the tub, ensuring the
3 connection ports on the Top Liner line up with the 3 holes
on Foam Panel 1, and the Bottom Liner.
NOTE:
Ensure O-Ring Gaskets are in place on all connection
ports.
4. Connect the Portable Control Unit to the Spa
Position the PCU next to the spa, remove the Inflation Hose and align the Connection
Hoses to the spa. Use slight force to evenly push the end of the connector hose into the
PCU’s connector port. Screw to tighten and seal the connector. Attach the Aromatherapy
canister to the blower port of the PCU. Attach the remaining connector to the aromatherapy
port, and attach the other end to the corresponding connection on the spa.
NOTE:
Ensure
connectors have
‘o’-ring gaskets in
proper postion
5. Install the Filter Cartridge
Open the Filter Housing lid. Put the new filter cartridge into the cartridge chamber.
Replace Filter Housing Cap and seal by screwing Cap Fitting on.
NOTE:
Ensure orange ‘o’-ring is placed correctly inside housing.
6. Pre-Fill Check
Ensure that the drain outlet is extended for future draining/access. Check the stopper on the
bottom of the spa and the Drain Cap, ensure both are closed tight. Fill the spa with water using
a garden hose until reaching the water level printed on both sides of the interior spa wall. These
lines are used to ensure that your spa remains level.
NOTE:
PCU must be connected to the spa prior to filling.
NOTE:
Do not use hot water to fill spa.
7. Purge Air From Portable Control Unit
Unscrew the Air Valve counter-clockwise and release the air until a small amount of water is
coming out, then screw the Air Valve clockwise tightly. Use a towel to dry off the PCU.
IMPORTANT:
Make sure PCU is turned off, and all Inlet/Outlet Caps are removed before
performing this step.
8. Thermal Blanket
Place Thermal Blanket on water surface
with the bubbles facing down for more
efficient heating and improved heat
retention.
Part 5
USAGE
Press the ‘Up’ and ‘Down’ arrows to set desired temperature, and press ‘HEAT’ to start the
heater. Place lid on the spa while heating. It can take 24-48 hours for your spa to reach its
set temperature. See Part 3 for complete list of Control Functions.
Lock the Buckle
Push the square pad upwards to lock and downwards to unlock.
X
NOTE:
Connectors must
be held straight
when attaching.
Attaching at an
angle can result
in damage to the
connector.
10
