| 11
EN-Rev IM/GN-EN/1.0 Copyright © January, 2023. CSI Solar Co., Ltd.
Portrait installation two rows:
Note: Modules in adjacent rows need to be rotated 180 degrees for proper installation.
CS6W-MB-AG
CS6W-TB-AG
Portrait installation one row Leap-frog
(for single-axis tracker):
The maximum distance between two adjacent module frames should be within 50 mm (1.96 in) for the side with mounting clamps,
and within 25 mm (0.98in) for the side without mounting clamps, in order to meet the system cable scheme.
CORRECT CONNECTION OF CONNECTORS
Make sure that all connections are safe and properly mated.
The PV connector should not be subject to stress from the
exterior. Connectors should only be used to connect the
circuit. They should never be used to turn the circuit on and
off.
Connectors are not waterproof when unmated. When
installing modules, connectors should be connected to
each other as soon as possible or appropriate measures
(like using connector endcaps) should be taken to avoid
moisture and dust penetrating into the connector.
If end caps are present on un-mated connectors, carefully
remove by hand the end caps before connecting the
connectors. Do not use any sharp tool which may damage
the connector. The use of tools is not needed.
Positive connector endcap
Negative connector
endcap
Do not
connect different connectors (brand and model)
together.
Do not
clean or precondition the connectors using
lubricants or any unauthorized chemical substances.
For CS6R/CS6RA-H-AG modules, do not short-circuit the
modules before full operation.
USE OF SUITABLE MATERIALS
Only use dedicated solar cable and suitable connectors
(wiring should be sheathed in a sunlight-resistant conduit
or, if exposed, should itself be sunlight-resistant) that meet
local fire, building and electrical regulations. Please ensure
that all wiring is in perfect electrical and mechanical
condition.
Installers may only use single-conductor cable listed and
labeled as PV wire which is 90°C wet rated in North
America, and single conductor cable with a cross section
area of at least 4 mm² (12 AWG), 90°C wet rated in other