20
Canarm Octa-Lite 8LEC Series
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A
A
B
B
C
C
D
D
SHEET
1
OF
1
DRAWN
CHECKED
QA
MFG
APPROVED
sales
5/15/2019
DWG NO
19.05.15 IOM Page 5.png
TITLE
SIZE
D
SCALE
REV
0.25 : 1
6
HANGING THE FAN
Before installation all set screws
must
be checked, and tightened where necessary, before installation.
6.1 Attach Extension Tube (to Upper Yoke):
Attach the extension tube to the upper yoke with the hardware
shown.
Before tightening the bolts, allow the fan to hang freely from the
structure to allow the fan to rest perpendicularly from the floor.
Tighten bolts to 90 ft-lb (122 N-m) using a 3/4” socket and torque
wrench.
Single Pivot Hardware (supplied):
a.
(2) 1/2” - 13x 3 1/2” GR 5 Bolt
b.
(4) 1/2” Flat Washer
c.
(2) 1/2”-13 Nylock Nut
Cable End Detail
The safety cable is a critical safety feature of the fan and must be installed correctly.
Le câble de sécurité est une caractéristique de sécurité essentielle de la soufflante qui doit être installé
correctement.
WARNING/ AVERTISSEMENT
!
6.2 Secure Upper Safety Cable:
Secure the safety cable to the I-beam or angle iron by wrapping the safety cable around it, threading
the cable through the 17/32” open hole on the top of the extension tube, and securing the ends with
the gripple fastener as shown. The cable must have as little slack as possible. Securely tighten the
gripple.
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
Page. 20
DRAWN DATE:
XX.XX.XX
DRAWN BY:
XX
PART NUMBER:
XXXX
REV:
_001
THIS DRAWING IS THE EXCLUSIVE PROPERTY OF SKYBLADE FAN COMPANY AND CANNOT BE REPRODUCED OR
DISCLOSED TO ANY THIRD PARTY WITHOUT THE AUTHORIZATION OF SKYBLADE FAN COMPANY
MATERIAL:
XXXXXXXX
ALL DIMENSION ARE IN INCHES
UNLESS OTHERWISE STATED
c
b
a
